How does Traffic Lab use studies to calibrate its simulator?
Traffic Lab calibrated its main highway entrance against one German design capacity for four continuous lanes. Simulated hourly counts at other desired speeds and a field comparison at a work zone show how the setting behaves in other cases.1
What was calibrated?
At the main entrance, vehicles wait for a gap large enough to enter while moving. The calibration set the net time gap in this entry rule to 1.7 seconds. The reference scenario had four continuous lanes, no ramp and a desired speed of 100 km/h.1
The German highway capacity manual (HBS) gives the design values used to calculate the benchmark. The value of 7,120 vehicles per hour is interpolated between the 10% and 20% heavy-vehicle columns for a 12% share. The model median of 7,196 vehicles per hour was about 1.1% higher than the benchmark.12
What did the other scenarios check?
After calibration, the team tested the reference road at desired speeds of 80 and 120 km/h. A field study at a work zone in North Rhine-Westphalia provided a benchmark for the lane drop. The work zone had a different gradient, vehicle mix and measurement method. The calibration result and the follow-up comparisons describe those specific conditions.13
What a calibration figure tells you
A fitted value only shows that the model matches that one case. Whether it also holds at another speed or a narrower cross-section takes an independent measurement.
Test it in the simulator
Open the reference road with four continuous lanes at a desired speed of 100 km/h.