# How many vehicles can pass a one-lane highway work zone at 80 km/h?

Researchers estimated a **nominal capacity of 1,739 vehicles per hour** in the affected direction at one work zone in North Rhine-Westphalia, Germany.[^1]

[HTML version](https://onemorelane.org/en/faq/one-lane-highway-work-zone-80-kmh/)

![Orange traffic cones mark off part of a highway carriageway.](https://onemorelane.org/photos/works-960.webp)

Illustrative photo · [Julia A. Keirns / Unsplash](https://unsplash.com/photos/dA71vYzTgRs)

## What the researchers measured at the work zone

At site NW 2012\_805, one 3.75-metre lane remained open in the measured direction. The road had a 3% uphill gradient and 7.5% of the traffic was heavy vehicles. The report used the 99th percentile of observed hourly traffic counts as the nominal capacity for this site.[^1]

## How much traffic can the simulated bridge carry?

Two approach lanes merge into one bridge lane on the level simulated road. The desired speed is 80 km/h and trucks make up 12% of requested vehicles. The median across three hour-long runs is **around 5% above the nominal capacity** at the measured site.[^2]

Work zone measurements and simulation at 80 km/h

| Measure | Vehicles/h |
| --- | ---: |
| Work zone · nominal capacity[^1] | 1,739 |
| Work zone · busiest measured hour[^1] | 1,759 |
| Simulation · median of three hour-long runs[^2] | 1,827 |

## What the figure means for a queue

Dividing 3,600 seconds by 1,739 vehicles gives a little over two seconds between passages. That is an average, not a gap that individual drivers should aim for.

If 1,900 vehicles arrive in an hour and 1,739 are served, 161 trips remain outstanding. A short burst of arrivals can create a long queue well before the hour ends; evenly spread arrivals look different. Whether the figure applies to another work zone depends on gradient, lane width, vehicle mix and demand.[^1]

## Try it yourself

Open the one-lane bottleneck with a desired speed of 80 km/h. Press Start and watch the count at the end of the bridge and the queue at the merge.

- [2 → 1 · 80 km/h](https://onemorelane.org/en/highway/?map=highway&preset=custom&seed=1187&lanes=2&exitLanes=1&speed=80&attention=80&demand=160&style=balanced&extended=0)

![Vehicles from two approach lanes queue in front of the simulated single-lane bridge.](https://onemorelane.org/faq-preview-2-1-80.webp)

## Related questions

- [How many vehicles per hour can a two-, three- or four-lane highway carry?](https://onemorelane.org/en/faq/hourly-highway-capacity-by-lane-count/index.md)
- [How do heavy vehicles and uphill gradients affect highway capacity?](https://onemorelane.org/en/faq/heavy-vehicles-gradients-highway-capacity/index.md)
- [How many vehicles pass through one highway lane at 60, 80, 100 or 120 km/h?](https://onemorelane.org/en/faq/one-highway-lane-throughput-at-60-80-100-120/index.md)

## Sources

[^1]: [Geistefeldt et al. (2024) · BASt V 378, Tables 5-1 and 5-2, pp. 75 and 80 (German)](https://bast.opus.hbz-nrw.de/files/2914/V378%20Gesamtversion%20BF.pdf)
[^2]: [Traffic Lab · Comparing the simulator with real traffic](https://onemorelane.org/en/highway/#modellvergleich)
